Skip to content
Vulpine
Esc
↑↓navigate↵open⌘Jpreview
On this page

Vulpine in a browser

Vulpine in a browser, the web app: what it shows (a call frame, the transcript, the panel), how to build, install, serve and open it on the gateway host at 127.0.0.1:8794, and the showcase that needs no gateway.

Living doc, checked against the code 2026-11-14

The web app is Vulpine in a browser tab: a full-screen call with portraits, a frame around them and a running transcript. It talks to the same gateway as the desktop app, so a second screen can show the conversation while you speak. Its look is called Vigil.

What it shows

  • A call frame. Five frames lay out the same conversation for a desk or a phone. The Look pane picks one, and ?frame=<id> in the address picks one for a single visit. A phone in portrait gets the Transceiver frame by default.
  • The transcript, written as the turn happens: your words, then the reply.
  • The panel, when a reply shows a chart, a table or a card beside the speech.

Open it

The web app is served by the gateway host on loopback, so open it in a browser on that Mac:

  1. Build it: just apps::vigil-build.
  2. Put the build in place: just apps::vigil-install.
  3. Serve it: just apps::vigil-serve-install. It runs as a LaunchAgent on 127.0.0.1:8794 and restarts itself after a crash.
  4. Open http://127.0.0.1:8794/. The page connects to the gateway on ws://127.0.0.1:8780.

Loopback counts as a secure origin, so the page may use the microphone and WebGPU. Nothing else on your network can reach it.

Try it without a gateway

just apps::vigil-showcase opens /showcase.html, which plays a scripted call through every frame. The installed build serves the same page at http://127.0.0.1:8794/showcase.html.

To work on the app itself, just apps::vigil-dev runs it from the source with live reload.

Was this page helpful?